I can not use the web interface to set up a digital output signal on an alarm using the web interface. If I use the camera keyboard it works fine. Step by step instructions. 

1. start with a "clean" camera 
2. set up a spot in the web interface 
3. set up an alarm to trigger on the spot 
4. set DO 1 to trigger on the alarm set up in step 2. 
5. trigger the alarm, for example by increasing temperature over 30 degrees. 

Result: the digital output will not go high

 

A file in the camera system folder has to be updated 
Before update, make sure the application and web filekits are versions baseDisk 1.4.2 and webDisk 1.4.0 
Please contact FLIR service center for assistance.